Nesco T1000-12 Manuel d'utilisateur télécharger pdf (Page 6)

English

Toasting tips

• Toasting is a combination of drying and cooking the bread and, because moisture

levels differ from one bread to another, toasting times can vary.

• For slightly dry bread, use a lower setting than normal.

• For fresh bread or whole wheat bread, use a higher setting than normal.

• Bread which has a very uneven surface will require a higher setting.

• Thicker cut pieces of bread (including crumpets) will take longer to toast -

sometimes signicantly longer. This is because more moisture must be evaporated

from the bread before toasting can occur. Very thick pieces of bread may require two

toasting cycles.

• When toasting raisin or other fruit breads, remove any loose raisins or fruit from the

surface of the bread before putting it into your toaster. This will help prevent fruit

pieces from falling into your toaster or sticking to the guard wires in the toasting

slot.

• Single slice toasting - If you are toasting a single slice of bread, set the browning

control to a lower setting than normal. By using a lower setting when toasting a

single slice of bread, it will not be over toasted.

• If your toaster jams:

• Never use a knife or any other utensil or implement to remove jammed bread.

• Never insert your ngers into the bread slots.

• Switch the toaster off at the power supply socket and unplug it.

• Allow the toaster to completely cool down.

• Carefully ease the bread out of the toaster being careful not to damage the

heating element.

Care and Cleaning Instructions

• Always switch off, unplug and allow the toaster to cool down before moving, cleaning

or storing. Never immerse the toaster or power cord and plug in water or any other

liquid.

• Clean the outside of your toaster with a damp cloth then dry thoroughly.

• Never use harsh, abrasive or caustic cleaners.

• Crumb removal

• It is important that crumbs are not allowed to build up inside your toaster. Excess

crumbs are unhygienic and could catch re.

• Crumbs can be removed by sliding the crumb tray out from the bottom of your

toaster.

• You can then tip the crumbs out. Always make sure that your toaster has completely

cooled down and is disconnected from the power supply before removing crumbs.

• Never use your toaster without the crumb tray tted. Always replace the crumb tray

before using your toaster.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

Nesco T1000-12 Manuel d'utilisateur Page 6